![]() They even offer to take a look at my design and the lighting. V1tech customer service was excellent and vary helpful. ![]() Once the error was corrected and the miss communication. Errors happens, and I understand perfectly. V1tech reached out to me explaining there was an error with my shipment replacement. Unfortunately I received poor service and a lack luster backplate. The only reason I gave them 3 stars is because a friend order a custom backplate at roughly the same time and I see how nice their work can look. Well its has been over a week and I have not heard from the company at all or received new cables. The issue I have is that the cable giving to me for the icue does not work right and after roughly a week of explaining they said they will mail me new cables. Though that’s an oversight on my part, but an email from the designer would have been a nice customer service on the company part. Due to a lack of explanation on what areas are less likely to shine. I ordered the custom design with text lighting. Connect the other side to the LED connector. Option 4 (Optional/Sold Separately): Connect to a Gigabyte/Aorus Motherboard Fusion 5V 3 Pin VDG Header. In Corsair iCUE’s software make sure to set the product to * 2 LED STRIPS*as ours are denser! Option 3 (Optional/Sold Separately): To use Corsair iCUE to control and power your LEDs, simply connect the Corsair iCUE cable adapter to the RGB Cable, and then plug in the adapter into a Corsair Commander Pro or Corsair Node Pro unit. Option 2 (Optional/Sold Separately): To use the RF remote to control your LEDs simply connect the SATA Power Cable to any SATA Power cable from your power supply unit. Make sure not to connect to a 12V 4 pin header, as that will kill the LEDs. Option 1 (Included): Connect the RGB Cable directly into your motherboards 3 Pin 5V RGB Header, Razer Chroma Addressable RGB Controller, EKWB D-RGB Loop Connect, or your own 5v 3Pin Controller. See below options on how to power/control the LEDs. ![]() ![]() Install your graphics card into your system.Īll our RGB Mod Parts come with this connector on the cable by default. Graphics Card Backplate directly over the rear of your graphics card (double-check to ensure that the backplate is oriented the correct way by aligning with any SLI or PCIe power cutouts if present. *Note: Ensure that as much surface area is covered as possible, start with the far corners of the graphics card and evenly distribute magnets/adhesive as you work inward to ensure that as much surface area is covered as possible for a secure installation.ģ) Peel the protective plastic on the other side of the double-sided tape and position the V1 Tech Custom. If a semi-permanent installation is desired, apply the provided double-sided tape directly to the tallest screws* on the back of your graphics card. Place the magnets onto the tallest screws* on the back of your graphics card with the tape facing away from the graphics card. 2) If you opt to use the provided magnets for an easily removable installation, first apply the provided double-sided tape to one side of the magnets by peeling the protective plastic on the tape and sticking the tape directly to the magnet. 1) To install your V1 Tech Custom Graphics Card Backplate, we recommend first removing the graphics card from your PC. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |